Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 62)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
62
WPA
This firmware version allows only Pre-Shared Keys (PSK) for authentication.
Security suite: 0=none, 1=WEP, 2=WPA, 3=WPA2/802.11i (0) ? 2
Change key (N) ? Y
Display key (N) ?
Key type 0=hex, 1=passphrase (1) ? 1
Enter key: ***********************
Encryption: 0=TKIP, 1=TKIP+WEP (0) ?
Change key Select (Y (Yes) to modify the currently configured key.
Display key Select (Y) Yes at the prompt to show the currently configured
key/passphrase
Key type Indicate whether the new key is in hexadecimal or passphrase
format.
Enter key Enter the passphrase. The maximum length is 63 characters.
Note: Lantronix recommends using a passphrase of 20
characters or more for maximum security.
Encryption Set the type to the minimum required security level. The “+” sign
indicates that the group (broadcast) encryption method is
different from the pairwise (unicast) encryption (WEP and TKIP).
802.11i/WPA2-Personal
Security suite: 0=none, 1=WEP, 2=WPA, 3=WPA2/802.11i (0) ? 3
Change key (N) ? Y
Display key (N) ?
Key type 0=hex, 1=passphrase (1) ?
Enter key: ***********************
Encryption: 0=CCMP, 1=CCMP+TKIP, 2=CCMP+WEP, 3=TKIP, 4=TKIP+WEP
(3) ?
Change key Select (Y) Yes to modify the currently configured key.
Display key Select (Y) Yes to show the currently configured
key/passphrase.
Key type Indicate whether the new key is in hexadecimal or
passphrase format.
Enter key Enter the passphrase. The maximum length is 63 characters.
Lantronix recommends using a passphrase of 20 characters
or more for maximum security.
Encryption Set the type to the minimum required security level. The “+”
sign indicates that the group (broadcast) encryption method
is different from the pairwise (unicast) encryption. For
example, for CCMP+TKIP, CCMP is the pairwise encryption
and TKIP is the group encryption. CCMP is the default for
WPA2.
Fixed or Automatic Data Rate
MatchPort permits the control of the transmission rate. Select 0 to set a fixed data
rate or select 1 to set an automatic data rate. The default is 1 (auto fallback).