Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 27)

Configuration Using Web-Manager
MatchPort b/g™ User Guide
27
communication. It indicates the end of transmission.
Pack Control
Enable Packing Select the checkbox to enable packing on the MatchPort.
Two firmware-selectable packing algorithms define how and
when packets are sent to the network. The standard algorithm
is optimized for applications in which the unit is used in a local
environment, allowing for very small delays for single
characters, while keeping the packet count low. The alternate
packing algorithm minimizes the packet count on the network
and is especially useful in applications in a routed Wide Area
Network (WAN). Adjusting parameters in this mode can
economize the network data stream.
Idle Gap Time Select the maximum time for inactivity. The default time is 12
milliseconds.
Match 2 Byte Sequence Use to indicate the end of a series of data to be sent as one
group. Two bytes must occur sequentially to indicate to the
MatchPort the end of the data collection.
Send Frame Immediately After the detection of the byte sequence, indicates whether to
send the data frame or the entire buffer. Select Yes to send
only the data frame. The default setting is No.
Match Bytes Use to indicate the end of a series of data to be sent as one
group. Set this value to 00 if specific functions are not needed.
Send Trailing Bytes Select the number of bytes to send after the end-of-sequence
characters.
Flush Input Buffer (Serial to Network)
With Active Connect Select Yes to clear the input buffer with a connection that is
initiated from the device to the network.
With Passive Connect Select Yes to clear the input buffer with a connection initiated
from the network to the device.
At Time of Disconnect Select Yes to clear the input buffer when the network
connection to or from the device is disconnected.
Flush Output Buffer (Network to Serial)
With Active Connect Select Yes to clear the output buffer with a connection that is
initiated from the device to the network.
With Passive Connect Select Yes to clear the output buffer with a connection initiated
from the network to the device.
At Time of Disconnect Select Yes to clear the output buffer when the network
connection to or from the device is disconnected.
Connection Settings - TCP
To configure a channel’s TCP settings :
1. On the main menu, click Connection to open the Connection Settings page for
the channel.