Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 42)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
42
Figure 5-4. Change Setup Menu Options
Change Setup:
0 Server
1 Channel 1
2 Channel 2
3 E-mail
4 WLAN
5 Expert
6 Security
7 Defaults
8 Exit without save
9 Save and exit Your choice ?
4. Select an option on the menu by entering the number of the option in the Your
choice ? field and pressing Enter.
View the current configuration by pressing Enter from the Change Setup menu.
To enter a value for a parameter, type the value and press Enter. To confirm a
current value, press Enter (without entering parameters).
5. When finished, save the new configurations (9 Save and exit). The unit reboots.
Server Configuration
The unit’s basic server (network) values display when you select Server (option 0
from the Change Setup menu). The following sections describe the configurable
parameters within the Server configuration menu.
Network Mode
Select the network mode for the MatchPort. Options available are Wired Only,
Wireless Only, and Bridging. (For more information on Ethernet-to-wireless
bridging, see
9: Wireless Bridging .)
Network Mode <0=Wired Only 1=Wireless Only
2=Bridging >:
Set the IP Address
If DHCP is not used to assign IP addresses, enter it manually. The IP address must
be set to a unique value in the network. Enter each octet and press Enter between
sections. The current value displays in parentheses.
IP Address : ( 0) ( 0) ( 0) ( 0) _
Set the Gateway IP Address
The gateway address, or router, allows communication to other LAN segments. The
gateway address should be the IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within the local network.
The default is N (No), indicating the gateway address has not been set. To set the
gateway address, type Y. At the prompt, enter the gateway address.