Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 41)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
41
Figure 5-2. Change Setup Menu Options
Change Setup:
0 Server
1 Channel 1
2 Channel 2
3 E-mail
4 WLAN
5 Expert
6 Security
7 Defaults
8 Exit without save
9 Save and exit Your choice ?
6. To select a menu option, enter the number of the option in the Your choice ?
field and press Enter.
View the current configuration by pressing Enter from the Change Setup menu.
To enter a value for a parameter, type the value and press Enter. To confirm a
current value, press Enter (without entering parameters).
7. When finished, save the new configurations (9 Save and exit). The unit reboots.
Serial Port Access
To configure the unit through a serial connection:
1. Connect a console terminal or PC running a terminal emulation program to serial
port 1. The default serial port settings are 9600 baud, 8 bits, no parity, 1 stop bit,
no flow control.
2. Reset the MatchPort unit by cycling the unit's power (turning the power off and
back on). Immediately upon resetting the device, enter three lowercase x
characters (xxx).
Note: The easiest way to enter Setup Mode is to hold down the x key at
the terminal (or emulation) while resetting the unit. You must do this
within three seconds of resetting the MatchPort.
Upon connection, the following information displays:
Figure 5-3. MAC Address
MAC address 00204A89E06A
Software version V6.7.0.0RC6 (100118)
AES library version 1.8.2.1
Press Enter for Setup Mode
3. To enter the Setup Mode, press Enter within 5 seconds.
Note: The connection fails if you do not press Enter within 5 seconds.
The configuration settings display, followed by the setup menu options: