Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 21)

Configuration Using Web-Manager
MatchPort b/g™ User Guide
21
DHCP Select Enable to permit Dynamic Host Configuration Protocol
(DHCP). DHCP automatically assigns a leased IP address to
the MatchPort unit.
AutoIP The MatchPort generates an IP in the 169.254.x.x address
range with a Class B subnet. Select the Enable checkbox to
enable this feature.
DHCP Host Name Enter the name of the host on the network providing the IP
address.
Note: We do not advise disabling BOOTP, DHCP, and Auto-IP (all three
checkboxes) as the only available IP assignment method will then be ARP or
serial port.
4. Click the OK button when finished.
Static IP Address Configuration
To assign an IP address and its network configuration manually:
1. Click Network from the main menu.
2. Select Use the following IP configuration.
3. Enter the following (as necessary):
IP Address If DHCP is not used to assign IP addresses, enter it manually
in standard decimal-dot notation. The IP address must be set
to a unique value in the network.
Subnet Mask A subnet mask defines the number of bits taken from the IP
address that are assigned for the host part.
Default Gateway The gateway address, or router, allows communication to
other LAN segments. The gateway address should be the IP
address of the router connected to the same LAN segment as
the unit. The gateway address must be within the local
network.
DNS Server The DNS server allows the name of a remote machine to be
resolved automatically. Enter the IP address of the DNS
server. If the device is DHCP enabled, the DHCP server
provides the DNS server IP address, which will override this
configured value.
Note: This setting is applicable only in Manual Connection
mode.
4. Click the OK button when finished.