Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 53)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
53
Modem Mode
Command Function
ATDTx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
ATD0.0.0.0
Forces the unit into Monitor Mode. Uses remote IP address and
port settings to initiate a connection.
ATD or ATDT
Forces the unit into Monitor Mode. Uses remote IP address and
port settings to initiate a connection.
ATDx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
ATH Hangs up the connection (Entered as +++ ATH).
ATS0=n
Enables or disables connections from the network going to the
serial port.
n=0 disables the ability to make a connection from the network to
the serial port.
n=1-9 enables the ability to make a connection from the network
to the serial port.
n>9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Note: The unit recognizes these AT commands as single commands such as
ATE0 or ATV1; it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the MatchPort’s ability to send the escape sequence. The default is
Y (Yes) (send the escape sequence).
Show IP addr after 'RING'
Disable or enable the MatchPort's ability to show the IP address after RING in
Modem Mode. The default is Y (Yes), to show the IP address.
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increment the source port. The MatchPort increments the port number
used with each new connection.