Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 49)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
49
For example, if the remote IP address already configured in the
unit is 129.1.2.3, then an example command string would be
C3/7. (This would connect to 129.1.2.3 and port 7.) You may
also use a different ending for the connection string. For
example, C50.1/23 would connect you to 129.1.50.1 and port 23.
If an IP address does not follow the first command string
character (which is "C"), the subsequent character string is
interpreted as the host name and domain to be used in DNS
lookup. This character string can include a destination port
number as well. The port number can be preceded by either a
forward slash (/) or a colon ( : ).
Table 5-8. Manual Connection Address Example
Command String Result if remote IP is 129.1.2.3 and remote port is 1234
C121.2.4.5/1 Complete override; connection is started with host 121.2.4.5, port 1
C5 Connects to 129.1.2.5, port 1234
C28.10/12 Connects to 129.1.28.10, port 12
C0.0.0.0/0 Enters Monitor Mode
8Cwww.lantronix.com
/80 Tries to connect to the Lantronix web server if the
(www.lantronix.com) is configured in the DNS
server database.
Autostart (Automatic
Connection) The unit automatically attempts a connection to the remote IP
address and port after booting up.
Hostlist If this option is set to True, the device server scrolls through the
host list until it connects to the first available device listed in the
host list table. Once it connects, the unit stops further attempts. If
this connection fails, the unit continues to scroll through the table
until it is able to connect to the next available IP address in the
host list.
The host list supports a minimum of 1 and a maximum of 12
entries. Each entry contains the IP address and the port number.
The hostlist is disabled for Manual and Modem Modes. The unit
will not accept a data connection from a remote device when the
hostlist option is enabled.