Connection settings - udp – Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort User Manual
Page 30
Configuration Using Web-Manager
MatchPort b/g™ User Guide
30
through the table until it is able to connect to another IP in the
host list.
The host list is disabled for Manual and Modem Modes. The
unit will not accept a data connection from a remote device
when the host list option is enabled.
For information on configuring the host list, see
on page
LED
Select Blink for the status LEDs to blink upon connection, or
select None for no LED output.
Disconnect Mode
On Mdm_Ctrl_In Drop
Set to Yes for the network connection to or from the serial port
to disconnect (drop) when Modem Control In transitions from
an asserted state to not asserted state. The default setting is
No.
Hard Disconnect
When set to Yes, the TCP connection closes even if the
remote site does not acknowledge the disconnect request.
Check EOT (Ctrl+D)
Choose Yes to drop the connection when Ctrl+D or Hex 04 is
detected. Both Telnet Com Port Cntrl and Disconnect with
EOT must be enabled for Disconnect with EOT to function
properly. Ctrl+D is only detected going from the serial port to
the network.
Inactivity Timeout
Use this parameter to set an inactivity timeout. The unit drops
the connection if there is no activity on the serial line before
the set time expires. Enter time in the format mm:ss, where m
is the number of minutes, and s is the number of seconds. To
disable the inactivity timeout, enter 00:00.
Connection Settings - UDP
To configure a channel’s UDP settings
:
1. On the main menu, click Connection for either Channel 1 or Channel 2 to open
the Connection Settings page for the selected channel.
2. In the available fields, enter the following information:
Connect Protocol
Protocol
Select UDP from the drop-down list.