Losi LOSB9563 User Manual
Page 9

LOSB9535 Xcelorin Electronic Speed Control v1.1 Page 9
4. Turn the power on to the ESC, wait for the Blue (or Blue/Yellow) LED to
come on.
5. Disconnect the Signal wire for the ESC from the receiver.
6. Connect the Signal wire to the top of the AQPC, ensure it is connected
correctly.
7. Pay close attention to the ESC LEDs and you will notice the Red LED flash,
and on the AQPC the Red LED will come on. If you do not notice the ESC Red
LED flash, you can unplug the Signal wire from the QPC and reconnect again to
verify the operation of the Red LEDs. Once you see the ESC Red flash and the
QPC turn on Red, the ESC has accepted the programming.
8. Disconnect the Signal wire from the QPC, turn off the power switch.
9. Reconnect the signal wire into the receiver.
10. The ESC has been updated and you are ready.
Note: If you should happen to lose any of your jumpers they are the
same jumpers used with computers and easily obtained at a computer
store.
ESC Warning LEDs
• If the Battery low voltage cutoff (LVC) is reached the Blue LED will blink.