Losi LOSB9563 - Manual (Page 11)

LOSB9535 Xcelorin Electronic Speed Control v1.1 Page 11
Note: If you cannot get the ESC to Calibrate, you may need to reverse your
Throttle Servo on the transmitter.
3. Using the throttle trigger pull Full Throttle until the Green LED will flash then
the Blue LED will turn ON solid.
4. Next push the throttle trigger to Full Brake until the Blue will flash and the
Green and Blue LED’s are both ON solid. (With the blue LED on, the green led
may appear to be yellow)
5. Now return the throttle trigger to the Neutral position and the Blue and
green LED’s will flash and then come ON solid.
6. Turn off the vehicle/ESC power switch.
7. Turn the vehicle/ESC back ON; you are now ready to use the ESC.
Normal Operation
• After turning on the vehicle, the Blue LED will be on for normal operation.
ESC – reverse operation
Should you get into a situation that requires reverse, after you have applied
any brakes you may have needed, return the throttle trigger to the neutral
position. Wait a moment or two and then push the trigger forward for reverse.