Losi LOSB9563 User Manual
Page 35
LOSB9535 Xcelorin Electronic Speed Control v1.1 Page 35
When using any Lithium or M1 (A123) batteries, they must not be discharged to less
than 3.0V per cell.
•
No Cutoff
The choice is not available and NOT recommended when
using any type of Lithium battery.
•
Customize Voltage Cutoff (for Lithium Batteries) after selecting the number of
cells (2 or 3) the default voltage is displayed. For example, you select a 2S or 2-
cell battery; the default cutoff voltage will be 6.0V. You may raise this to protect
your expensive batteries in 0.1V increments up to 7.0V. For 3S or 3-cell, the
default cutoff is 9.0V and you may increase this up to 10.5V.
Brake / Reverse – This is only to determine if reverse is to be enabled or not.
You will find in racing, most tracks will not allow racing with reverse enabled.
•
Forward w/o Reverse
This is a Race setting - Reverse is disabled.
•
Forward with pause then Reverse: (DEFAULT)
General bashing
around (FUN) or racing if reverse is allowed for the event. The Electronic Speed
Control requires 2 seconds of continuous neutral from the transmitter prior to
allowing reverse to operate.