Losi LOSB9576 - Manual (Page 8)

LOSB9515 Xcelorin Electronic Speed Control v1.1 Page 8
Drag Brake – 40%
Throttle Limit – 80% of Full Throttle (was 60%)
Reverse Speed – 50%
Motor Timing - Low
Then follow the instructions for using the Quick Programming Card. You can
change one setting at a time or any combination. Making the above change is
ONLY overriding the active profile. At any time, you can reset the ESC to
profile #3 and the active profile is returned to the original profile #3 settings.
Selecting profiles
Notice that Profile #3 is set from the factory as the DEFAULT.
1. Turn the Transmitter on.
2. Turn the vehicle on.
3. With the ESC turned on and ready for operation, press & hold the setup
button until both the Yellow and Blue LEDs flash.
4. Release setup button.
5. The status LEDs flash to indicate the current profile setting.
LED status for each Profile below: