Losi LOSB9576 - Manual (Page 32)

LOSB9515 Xcelorin Electronic Speed Control v1.1 Page 32
Following the above example for an 8 - cell NiMH battery , you would select 5.0V and
then increase 6 steps up to 5.6V.
DO NOT USE the above setting with any type of Lithium battery pack
When using any Lithium or M1 (A123) batteries, they must not be discharged to less
than 3.0V per cell.
• No Cutoff The choice is not available and NOT recommended when using any
type of Lithium battery.
• Customize Voltage Cutoff (for Lithium Batteries) after selecting the number of cells
(2 or 3) the default voltage is displayed. For example, you select a 2S or 2-cell
battery; the default cutoff voltage will be 6.0V. You may raise this to protect your
expensive batteries in 0.1V increments up to 7.0V. For 3S or 3-cell, the default cutoff
is 9.0V and you may increase this up to 10.5V.
Brake / Reverse – This is only to determine if reverse is to be enabled or not.
You will find in racing, most tracks will not allow racing with reverse enabled.
• Forward w/o Reverse
This is a Race setting - Reverse is disabled.
•
Forward with pause then Reverse: (DEFAULT)
General bashing around (FUN) or racing if reverse is allowed for the event. The Electronic
Speed Control requires 2 seconds of continuous neutral from the transmitter prior to
allowing reverse to operate.