Losi LOSB9576 - Manual (Page 31)

LOSB9515 Xcelorin Electronic Speed Control v1.1 Page 31
C0101XX.LSC - 18 th Xcelorin
D0101XX.LSC - 10 th Xcelorin Sensored
E0101XX.LSC - 10 th Xcelorin SensorLess
F0101XX.LSC - Reserved
G0101XX.LSC - Reserved
Note: XX denotes the incremental release level
General TAB information
Battery Type –Select NiMH, or Lithium-Ion / Lithium Polymer batteries
Cutoff Voltage – This is a critical option to understand and used to protect Lithium or M1
batteries from being over-discharged
, which will shorten the life, cause damage to the
battery, or even result in Fire or Personal Injury.
When using NiMH batteries you do not need to set a cutoff voltage to protect the
batteries. NiMH batteries typically stop operating your vehicle before any damage occurs.
If you are using more than 6-cell NiMH batteries, you must adjust the cutoff voltage, for
example if you are using an 8-cell pack of NiMH batteries you would use a cutoff of 5.6V
volts (8 x 0.7V = 5.6V). If you are using fewer cells of NiMH batteries, a cutoff voltage of
4.0V will provide power for your radio system to operate and reduce the chance of losing
control.
•
No Cutoff The choice for racing used along with quality NiMH battery packs.
• Customize Voltage Cutoff (for NiMH Batteries) you can select a starting cutoff
voltage of 4, 5, 6, 9 or 12 volts. Then using the up/down to the right of the voltage
you can increase the voltage stepping up 0.1V between the selectable settings.