Losi LOSB9576 - Manual (Page 37)

LOSB9515 Xcelorin Electronic Speed Control v1.1 Page 37
If you are running in dusty or slippery surfaces, you will more than likely want
to use the lowest option.
• 0% • 15%
• 4% • 20%
• 8% (Default) • 25%
• 10% • 30%
• 12%
Legacy or 2.4GHz – This setting is intended to reflect what type of Radio
System you are using, i.e. Transmitter and Receiver.
Default is LEGACY because there are still many of the traditional 27MHz, 40MHz or 75MHz
systems in use.
If you use a 2.4GHz system
, then you can select this setting.
The Electronic Speed Control internal switching rate is increased with the 2.4GHz selection
and may cause interference with Legacy Radio Systems.
Neutral Deadband – This setting adjusts the amount of “Deadband” off
neutral on the throttle trigger. This is in Milli-Seconds
( MS ) and is the amount
of neutral when you pull the trigger.
The smaller the value the less “Deadband” or movement is required off-center
for the ESC to begin throttle functions.
Using a higher value for this setting will provide a wider Deadband.