Kontron COMe-cP2020 - Manual (Page 91)

www.kontron.com
COMe-P2020 User Guide
91
6.5.3 Examples of sconf Command Usage
6.5.3.1 sconf select
To change the setting, invoke the “sconf select” command.
Example:
6.5.3.2 sconf set
The setting of the chosen base configuration can be changed via the “sconf set” command. In the following example, the
“sconf info” command is used to show the current configuration. After that, “sconf set etsec2” and “sconf set etsec3” are
used to configure RGMII mode.
=> sconf select 7
Default configuration active
=========+-===============+-===============+-===============+-===============
Base | Serdes #0 | Serdes #1 | Serdes #2 | Serdes #3
Config | | | |
=========+-===============+-===============+-===============+-===============
|
< 0> | OFF OFF OFF OFF
|
**< 1>**| PCIEx4 @2.5 RC
|
< 2> | PCIEx1 @2.5 RC PCIEx1 @2.5 RC PCIEx2 @2.5 RC
|
< 3> | PCIEx2 @2.5 RC PCIEx2 @2.5 RC
|
< 4> | PCIEx1 @2.5 RC PCIEx1 @2.5 RC SGMII SGMII
|
< 5> | PCIEx2 @2.5 RC SGMII SGMII
|
< 6> | PCIEx1 @2.5 RC SRIOx1 @2.5 H SGMII SGMII
|
--[ 7]--| SRIOx1 @2.5 H SRIOx1 @2.5 H SGMII SGMII
|
< 8> | SRIOx4 @3.125H
eTSEC2 configured in SGMII mode
eTSEC3 configured in SGMII mode
SRIO host mode, device ID is 0
Boot ROM location is spi
=>