Elecraft KX1 Manual - Manual (Page 96)

E
LECRAFT
KX1
QUICK REFERENCE
MENU/EDIT
LED LED LEVEL (tap BAND or RIT);
LED TIMEOUT, use VFO knob
STL SIDETONE VOLUME LEVEL, 0-3
STP SIDETONE PITCH, 500-700 Hz
T-R QSK DELAY, 0-900 ms
RPT AUTOREPEAT DELAY, 0-255 sec
INP KEYING DEVICE: Hnd, PDn, PDr
IAB IAMBIC MODE, A or B
CFB AUDIBLE CW FEEDBACK,
OFF or 10-40 WPM in 5 WPM steps
SLO S-METER ZERO SET
SHI S-METER SCALE
B30 30-M BAND on/off
CAL VFO CALIBRATION (see manual)
BAT BATTERY WARNING THRESHOLD
ATU AUTO-TUNER MODE (see ATU manual)
RCL MEMORY RECALL (tap 1, 2, or VFO);
STORE (EDIT, tap 1, 2, or VFO;
hold rather than tap = high priority)
PLY MESSAGE PLAY (tap 1 or 2; tap VFO
knob for CW test mode, P=0);
RECORD (EDIT, tap 1 or 2)
Tap to enter menu, hold to edit (except RCL and PLY); use VFO knob to scroll menu or modify parameters
VFO KNOB
FUNCTIONS
TUNING RATE:
Tap for 10/100 Hz,
hold for 1 kHz
(5 kHz in LSB/USB
receive modes)
LOCK/UNLOCK:
RIT + VFO knob
HIGH-PRIORITY MEM:
BAND + VFO knob
SWITCH CW:
MENU + VFO knob
E L E C R A F T K X 1
EDIT
MENU
TX
RX RF GAIN
SPEED
BAND
POWER
ANT.
AF GAIN
CLR
RIT 0.5
FILTER
2.0
1.0
TUNE DISP
3 7 + S 1 5 9
1 2 3 RF
TAP: 10 HZ / 100 HZ
HOLD: 1 kHz
LAMP
ON
OFF
12V
1 2
KEY/
PADDLE
Tap once to show
band, twice (quickly)
to change bands.
Hold to set keyer
speed with VFO knob
BAND/SPEED
Tap for RIT on/off, hold for RIT clear RIT/CLR
Hold MENU + BAND;
tap any switch after
power is displayed
TUNE (key-down) :
Hold BAND + RIT;
norm, Smtr, battery
DISP (display mode):
Hold MENU + RIT;
norm, LSB, USB
RX MODE (sideband):