Elecraft KX1 Manual - Manual (Page 53)

52
E
LECRAFT
Locate the thermal pad. Leave it on the backing paper while you
remove the piece filling the hole near one end. Then remove the
backing and place the pad on the inside of the cover over the area you
sanded with the hole in the pad aligned with the hole in the cover (see
Figure 22).
Figure 22. Installing Thermal Pad.
Position the red filter over the LED display opening. Use the
clear tape to secure it on the top and bottom edges as shown in Figure
23. Even though the tape is transparent, keep it outside of the window
area so the edge of the tape is not visible from the front of the unit. Be
careful not to cover the pushbutton switch holes with the tape.
Figure 23. Installing Display Filter.