Elecraft KXPA100 Manual - Manual (Page 53)

53
Position the front panel so the LEDs and OFF/ON switch and, if equipped with the ATU, the TUNE and
MODE buttons fit through the openings. Secure it with screws, lock washers and spacers just as you did on the
rear panel (see Figure 24).
Figure 24. Replacing the Front Panel.
Replace the corner feet. Press each foot over the three screws, spacers and lock washers on the end panel,
and then replace the three screws, spacers and lock washers through the remaining holes into the side panel (see
Figure 17 on page 48).
Set the KXPA100 on its feet. Never operate it for more than a few seconds with the fins resting against a surface
that will impede the flow of cooling air (see Positioning the Amplifier on page 11)
That completes the reassembly of your KXPA100.