EFCO 433 Series - Manual (Page 90)

June 2012 PART NO. Y017 Page 90 of 90
Series 433 Triple Set Installation Instructions
SECTION X: Door Stop Installation
(Includes Offset and Center-Set Glazing)
Step 1) Door Stop Cut Length and Installation
Install the applied door stop into position on the door frame by spacing it off the
exterior face of the door frame at the appropriate dimension, depending on door
thickness. See Figures 126 and 127 below. Using STT6 fasteners 3" from each end
and 12" O.C., fasten the door stop to the door header and door jamb. After
determining that the door stops are in the correct position, apply the door stop cover
by snapping it into the door stop raceway.
SCREW SPLINE
JAMBS SIMILAR
8374
8357
9257
91559154
8373
[FIG. 127]
8373
9208
8374
1 63/64"
@ 1 3/4" DOOR
9154 9155
2 15/64"
@ 2" DOOR
91559154
4437
1 31/32"
@ 1 3/4" DOOR
9155
2 7/32"
@ 2" Door
9155
4437
[FIG. 126]
HORIZONTAL CUT LENGTH = DOOR OPENING WIDTH
VERTICAL CUT LENGTH = [DOOR OPENING HEIGHT minus HORIZONTAL
DOOR STOP HEIGHT minus THRESHOLD HEIGHT]