EFCO 433 Series - Manual (Page 39)

June 2012 PART NO. Y017 Page 39 of 90
Series 433 Triple Set Installation Instructions
SECTION IV: Unit Assembly
A. Screw Spline (Offset and Center-Set)
Dead Load Pin Installation
Outside Set Shown
Inside Set Similar
Use FW95 3” Dead Load Support Pin when
there is a Horizontal member on both
sides of the Transom Jamb or Vertical.
Use FW96 2” Dead Load Support Pin when
there is a Horizontal member on one side
of the Vertical or for Door Jambs with side
lites.
8354 8356
8355 8374
DIES SIMILAR TO
ONE’S SHOWN.
4374
8353