Detex DTX-4300 - Manual (Page 70)

This feature is useful considering the product only has
two relays; you can assign these relays to any of these
functions. There are only a few things to keep in mind
when assigning the outputs.
• Any virtual output can be assigned to any physical
output.
• A virtual output can be assigned to multiple physi-
cal outputs.
• A physical output can only have one virtual output
assigned to it.
To assign the outputs, use the following command:
10 # virtual output # physical output # **
The chart below shows the output options with the
corresponding value.
Virtual Outputs Physical Outputs
1 = Lock 1 = Main Relay
2 = Alarm Shunt 2 = Aux Relay
3 = Propped Door 5 = Audio Alert #1
4 = Forced Door
6 = Audio Alert #2
For example, to assign the Forced Door Output to the
Aux Relay, enter the following command in Program
mode:
10 # 4 # 2 # **
After entering this command, the Forced Door Output
is still assigned to Audio Alert #1. If you do not want
the audio alert to sound for Forced Door, you MUST
disable Audio Alert #1. To disable an output, enter a
0 for the virtual output. To disable Audio Alert #1 enter
following command:
10 # 0 # 5 # **
NOTE : The audio alerts use the local keypad sounder.
Audio Alert #1 is indicated by a ½ second on, ½ second
off beeping. Audio Alert #2 is indicated by a short beep
every two seconds.
Chapter 4: Programming 4.3 Programming Outputs
4-18 prox.pad plus Install/Program. Manual, PPP, D4b
Part No. 6105679, Rev. 1.1