Detex AO19-3 - Manual

104854 January 31, 2013
Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045
(830)-629-2900 / 1-800-729-3839 / Fax (830)-620-6711
E-MAIL: detex @ detex.com INTERNET: www.detex.com
The Detex Low Energy Automatic Door Operator must be installed to comply with the latest revision of
ANSI /BHMA A156.19 (American National Standard for Power Assist and Low Energy Power Operated
Doors) and upon completion of installation, the owner should have an inspection performed by an
AAADM certified inspector. In special applications where safety sensors are used on low energy doors,
the sensors and the related adjustments should comply with the criteria set forth in ANSI/BHMA A156.10
(American National Standard for Power Operated Pedestrian Doors). Failure to conform to these
requirements may cause operating failures which can result in serious injury or property damage.
It is the owner’s responsibility to assure the reliable and safe operation of this device; routine
service and inspection should be performed at least annually by an AAADM certified inspector.
More frequent service may be required when the operating environment or other conditions dictate or if
required by the local authority having jurisdiction. Proper operation should be checked everyday by the
owner. Detex Corporation accepts no liability for property damage, warranty claims or
personal injury, if this Detex product is not properly installed for compliance to these requirements by a
qualified automatic door operator installer and also properly maintained and inspected by the owner to
operate as required by ANSI/BHMA A156.19 (or ANSI/BHMA A156.10 where required).
DETEX Low Energy Automatic Door Operator
AO19-3
Dual Egress
104854 Page 1
CAUTION
Read this notice before installing or servicing
Installer’s Copy