Detex AO19-1 Push - Manual

104850 January 31, 2013
Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045
(830)-629-2900 / 1-800-729-3839 / Fax (830)-620-6711
E-MAIL: detex @ detex.com INTERNET: www.detex.com
The Detex Low Energy Automatic Door Operator must be installed to comply with the latest
revision of ANSI /BHMA A156.19 (American National Standard for Power Assist and Low Energy
Power Operated Doors) and upon completion of installation, the owner should have an inspection
performed by an AAADM certified inspector. In special applications where safety sensors are used
on low energy doors, the sensors and the related adjustments should comply with the criteria set
forth in ANSI/BHMA A156.10 (American National Standard for Power Operated Pedestrian Doors).
Failure to conform to these requirements may cause operating failures which can result in serious
injury or property damage.
It is the owner’s responsibility to assure the reliable and safe operation of this device; routine
service and inspection should be performed at least annually by an AAADM certified inspector.
More frequent service may be required when the operating environment or other conditions dictate
or if required by the local authority having jurisdiction. Proper operation should be checked everyday
by the owner. Detex Corporation accepts no liability for property damage, warranty claims or
personal injury, if this Detex product is not properly installed for compliance to these requirements
by a qualified automatic door operator installer and also properly maintained and inspected by the
owner to operate as required by ANSI/BHMA A156.19 (or ANSI/BHMA A156.10 where required).
DETEX Low Energy Automatic Door Operator
AO19-1
Single Door - Push
104850 Page 1
CAUTION
Read this notice before installing or servicing
Installer’s Copy