Detex 14DM Trim - Manual

DETEX 103129
INSTALLATION INSTRUCTIONS FOR MORTISE OUTSIDE LEVER TRIMS
Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045
(830)629-2900 / 1-800-729-3839 / Fax (830)620-6711
E-MAIL: [email protected] INTERNET: www.detex.com
103129 September 14, 2009
08DM, 08DMT, 08DMU
09DM, 09DMT, 09DMU
14DM, 14DMT, 14DMU
TOP GEAR
LOCKING BAR
RACK
CLUTCH GEAR
STOP PLATE
SPRINGS
SPRING
RETAINING PLATE
LEVER
RHR LHR
CENTER SCREW
INPUT SHAFT SCREW
SEE STEP H
LOCK SPRING
(09 TRIM ONLY)
CHANGING LEVER HANDING
A. Remove input shaft screw. (Remove input shaft if necessary).
B. Remove stop plate.
C. WARNING: Springs under pressure! Remove spring retaining plate. Carefully remove the springs.
D. (For 09 Function only) Switch lock spring to opposite side.
E. Remove top gear.
F. Loosen the clutch center screw approximately two (2) turns. Bend locking tab back to disengage with notch.
G. Slide the locking bar away from the rack (not necessary for 14 function). Remove the rack while rotating the lever.
H. Continue rotating the lever to the opposite side.
I. Rotate the lever to the position shown. Partially engage the rack and the clutch gear on the opposite side.
J. Rotate the lever until the rack is completely seated.
K. Insert the top gear.
L. Add permanent thread locking adhesive and tighten the clutch center screw. Bend tab over screw notch
so that screw cannot turn.
M. WARNING: Springs under pressure! Install the springs. Hold the lever in the open position, firmly
compressing the springs in place.
N. While holding the lever in the open position, replace the spring retaining plate and fasten the two (2) screws.
O. Reverse the stop plate and fasten the screw.
P. Replace input shaft screw. Handing complete.
LOCKING TAB
08 or 09 LEVER TRIM 14 LEVER TRIM