Carrier Access 770-0015 AM User Manual
Page 168
7-8
IP Router - Release 1.8
Verification Window
Trace Route
Method
widely used and has the best reliability. (Default).
trace route support probes on the particular UDP port. This method is not recommended.
Size
Define Packet Size. Range 0 - 65500
IP: Tos
Sets the IP type of service. Range 0x00 - 0xFF Hex. Default is 0.
Don’t Frag
Sets the "Don’t Fragment" flag in the IP header. This can be used along with the size setting to
determine the maximum payload size that can be sent between the router and the destination
without fragmentation occurring, the path MTU.
UDP Port
Sets the UDP port to send to. Range is 1 - 65535, with a default of 33434. This setting only
applies if the method is set to UDP.
Query: Number
Defines the number of probe packets sent to each hop along the route. Range is 1 - 10,. Default
is 3.
Wait
Defines the wait time between queries. Range is 0 - 250 ms. Default is 1 ms.
Timeout
Defines the query timeout. Range is 1 - 60 seconds. Default is 3 seconds.