Cabletron Systems 2208 - Manual (Page 69)

General Configuration Screen
2H22-08R SmartSwitch 2208 User’s Guide Page 5-25
If the time entered is a valid format, the message displays “SAVED OK”
at the top of the screen. If the entry is not valid, Local Management does
not alter the current value and refreshes the Device Time field with the
previous value.
5.7.7 Entering a New Screen Refresh Time
The screen refresh time is set between 3 and 99 seconds with a default of
3 seconds. To set a new screen refresh time, perform the following steps:
1. Use the arrow keys to highlight the Screen Refresh Time field.
2. Enter a number from 3 to 99.
3. Press ENTER to set the refresh time to the time entered in the input
field.
4. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER.
If the time entered is within the 3 to 99 seconds range, the message
“SAVED OK” displays at the top of the screen. If the entry is not valid,
Local Management does not alter the current setting, but it does refresh
the Screen Refresh Time field with the previous value.
5.7.8 Setting the Screen Lockout Time
The screen lockout time is set between 1 and 30 minutes with a default of
15 minutes. To set a new lockout time, perform the following steps:
1. Use the arrow keys to highlight the Screen Lockout Time field.
2. Enter a number from 1 to 30.
3. Press ENTER to set the lockout time in the input field.
4. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER.
If the time entered is within the 1 to 30 minute range, the message
“SAVED OK” displays at the top of the screen. If the entry is not valid,
Local Management does not alter the current setting, but it does refresh
the Screen Lockout Time field with the previous value.