Cabletron Systems 2208 - Manual (Page 124)

Chapter 5: Local Management
Page 5-80 2H22-08R SmartSwitch 2208 User’s Guide
There are two categories of commands in the command set.
• Built-in Commands - Allow you to access and manage network
devices. The commands are: arp, bridge, defroute, netstat, ping,
reset, show, traceroute, soft_reset, telnet, and link_trap.
• Special Commands - Allow you to exit from Network Tools. The
commands are done, quit, and exit.
The commands are presented in the following format:
command:
Syntax: Shows the required command format. It
indicates where arguments, if any, must be
specified.
Description: Briefly describes the command and its uses.
Options: Lists any additional fields in the appropriate
format which may be added to the command.
Example: Shows an example of the command.
NOTES
The conventions used in describing the commands in Network
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
user is in shown in bold Helvetica font
.
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.