Cabletron Systems 2208 - Manual (Page 153)

Installing Optional Fast Ethernet Interface Modules
2H22-08R SmartSwitch 2208 User’s Guide Page C-9
3. See Figure C-5 . Gently pull the faceplate of the 2H22-08R forward to
allow room for the Fast Ethernet Interface Modules to be aligned over
the connector.
4. Carefully lower the Fast Ethernet Interface Module onto the standoffs
while inserting the module connector into the associated motherboard
connector.
Figure C-5 Installing the Fast Ethernet Interface Module
!
CAUTION
When installing an FE-100FX or FE-100F3 module into the
2H22-08R, remove the rubber plug on the module before
proceeding.
!
CAUTION
In the following step, take care when inserting the Fast Ethernet
Interface Module into the Motherboard connector, so that the
pins do not bend. Otherwise, the Fast Ethernet Interface Board
and the Motherboard could be damaged.
2251-39
FE-100TX 10
100
Motherboard
Connector
Front
Standoffs
Rear
Standoff
Module
Module
Connector
7
8