Cabletron Systems 2208 - Manual (Page 151)

Installing Optional Fast Ethernet Interface Modules
2H22-08R SmartSwitch 2208 User’s Guide Page C-7
C.3 INSTALLING OPTIONAL FAST ETHERNET
INTERFACE MODULES
Figure C-3 shows the locations of the Fast Ethernet Interface Module
connectors for ports 7 and 8.
Figure C-3 Fast Ethernet Interface Module Connector Location
To install a Fast Ethernet Interface Module in port slot 7 or 8, proceed as
follows:
!
CAUTION
The FE-100F3 uses Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
!
CAUTION
The Fast Ethernet Interface Module and the 2H22-08R are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could damage the module or the 2H22-08R.
Optional Fast Ethernet
Interface Modules
Connectors
FRONT PANEL
TOP VIEW WITHOUT COVER
Redundant
Power
Supply Primary
Power
Supply