Cabletron Systems 2208 - Manual (Page 28)

Chapter 3: Installation
Page 3-2 2H22-08R SmartSwitch 2208 User’s Guide
3.2 UNPACKING THE 2H22-08R
To unpack the 2H22-08R and verify the contents of the shipment, proceed
as follows:
1. Open the carton and remove the packing material protecting the
2H22-08R.
2. Verify the contents of the carton as listed in Table 3-1 .
3. Remove the black and yellow tape seal on the non-conductive bag to
remove the 2H22-08R.
4. Perform a visual inspection of the device for any signs of physical
damage. If there are any items missing or damaged, contact Cabletron
Systems Global Call Center as described in
Section 1.7 .
3.3 INSTALLING OPTIONS
If the 2H22-08R is to be installed with an optional Fast Ethernet Interface
Module, refer to
Appendix C for installation instructions.
Table 3-1 Contents of 2H22-08R Carton
Item Quantity
2H22-08R 1
Antistatic Wrist Strap 1
Console Cable Kit 1
Rackmount Kit 1
Strain-Relief Bracket 1
Power Cord 2
NOTE
Install any optional equipment before proceeding to
Section 3.4 .