Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 81)

support.dell.com PowerVault 56F 16-Port Fibre Channel Switch Commands 4-25
%
'
The portLogClear command clears the data from the port log. The command syntax
is
portLogClear.
%
&%
The portLogDump command prints the port log without page breaks. The command
syntax is
portLogDump.
%
#
The portStatsShow command, when used with a port number, gives a static view of
the port status when the switch executed the command. For example, to update the
command and check if an error count is increasing, reissue the portStatsShow com-
mand to capture another snapshot. Fields for the portStatsShow command are
described in Table 4-15.
The command syntax is portStatsShow .
enc in Encoding errors inside of frames
crc err Frames with cyclic redundancy check (CRC)
errors
too shrt Frames shorter than minimum
too long Frames longer than maximum
bad eof Frames with bad end-of-frame delimiters
enc out Encoding error outside of frames
disc c3 Class 3 frames discarded
link fail Link failures (LF1 or LF2 states)
loss sync Loss of synchronization
loss sig Loss of signal
frjt Frames rejected with F_RJT
fbsy Frames busied with F_BSY
( (+
!!''
%