Installing a new fan assembly, Removing and installing a system board, Required tools – Dell PowerVault 56F (16P Fibre Channel Switch) User Manual
Page 113: Removing the system board, Installing a new fan assembly -5, Removing and installing a system board -5, Required tools -5, Removing the system board -5
support.dell.com
Repair and Replacement
6-5
)"#.!
1.
Inset the new fan assembly into the switch’s front assembly cavity.
2.
Tighten the four front thumb-screws.
$' 0
Replacing the system board involves removing the switch’s cover, removing the sys-
tem board, and installing the new system board.
0;, * <
9
#6 flat-head screwdriver
8
1.
Remove all cabling attached to the front panel.
2.
Remove all GBICs.
See “Removing a GBIC Module” found earlier in this chapter for instructions.
3.
Disconnect the power supply connector(s).
4.
Remove the system board module by loosening the captured screw located
between ports 7 and 9 and pulling the assembly out of the switch. See
Figure 6-5.
5.
Remove the new system board from its antistatic bag and place the old system
board into the bag.