Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 163)

support.dell.com Glossary 3
A loop is a configuration of devices (for
example, JBODs) connected to the fabric
via an FL_Port interface card.
12
"
Used to send detailed status/commands
from or to an SNMP managed device.
Management information base.
Multicast is used when multiple copies of
data are to be sent to designated multiple
destinations.
%!
The N_Port is the designation of an equip-
ment port connected to the fabric.
%!
The NL_Port is the designation of an
equipment port connected to the fabric in
a loop configuration via an FL_Port.
#
Network Node Manager Special Edition.
!.323! &"
The POST is a series of self-tests which
run each time the unit is booted or reset.
! &
Power-on self-test.
1
3
!*"
A chip that can only be programmed once.
!*
programmable read-only memory
*
random access memory
*&'
*%%&'"
R_A_TOV is used to time out operations
that depend on the maximum possible
time that a frame could be delayed in a
fabric and still be delivered. The value of
R_A_TOV is adjustable in 1-microsecond
increments over a range from 10 to
120 seconds.
*
read-only memory
revolutions per minute
storage area network.
subscriber connector
small computer system interface
.01
! !"
SNMP is a TCP/IP protocol that generally
uses the User Datagram Protocol (UDP)
to exchange messages between a man-
agement information base and a
management client residing on a network.
Since SNMP does not rely on the under-
lying communication protocols, it can be
made available over other protocols, such
as UDP/IP.
!
Simple Network Management Protocol
!4
The original standard for SNMP is now re-
ferred to as SNMPv1.
simple name server
*
static random-access memory
& !"
A trap is a mechanism for SNMP agents
to notify the SNMP management station
of significant events.
$!
User Datagram Protocol
$
Unicast routing provides one or more op-
timal path(s) between any of two