Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 75)

support.dell.com PowerVault 56F 16-Port Fibre Channel Switch Commands 4-19
3. In the program list, click Dell OpenManage PowerVault Manager, then click
PowerVault 51F Utilities, then click rshd.
The remote shell daemon starts. The cat.exe is run from the rshd.exe file
4. Start a Telnet session to a switch by typing the following command:
4@619 A
5. Log in as 4 by typing the following command:
4 4
6. Then type:
34 @G64H19 GA5@G'4GA5
@G4GA
For example:
<834 G!!G5GJ64G5GHHHG
NOTE: The host name can be the host IP address and the file name is a path to
the new firmware file.
The RSH server validates the user and delivers the file to the switch where it is
stored in flash memory, as shown in the following example:
46
7. Reboot the switch to initiate the new firmware.
8. After rshd.exe completes the download, stop rshd.exe by pressing .
To minimize any security exposure, terminate the RSH daemon.
NOTE: Idle the I/O before downloading the software.
The h command prints the shell history of the previous 20 commands. The older com-
mands are replaced by new commands. The shell history is similar to the UNIX Korn
shell history facility with an integrated line editor (similar to UNIX VI) that allows previ-
ously typed commands to be edited.
NOTE: The shell history is reset by a reboot.
%
The help command displays a list of commands in alphabetical order, with additional
lists of “grouped” commands.