Dell PowerVault 56F (16P Fibre Channel Switch) User Manual
Page 140
A-4
Installation and Troubleshooting Guide
REMPORT (3)
Removing an entry from a multi-
cast routing table failed.
Run the portLogShow command. Con-
tact Customer Support.
SPFCOST (3)
An error occurred with comput-
ing the multicast path tree.
Run the LSDbAllShow command. Con-
tact Customer Support.
NBFSM
NGBRSTATE
(2)
An error occurred in the neighbor
Finite State.
Check the neighbor’s state with the
nbrStateShow command.
If the state is not NB_ST_FULL, force a
state change with the portDisable com-
mand followed by portEnable.
After a few seconds, if the state is not
NB_ST_FULL, reboot both the local and
remote switches.
UCAST
ADDPATH (1)
A static path configuration failed.
Check command parameters.
RELICPDB (2)
The path selection task received
an E_Port SCN, but the port was
already ISL.
Run the ucastAllShow command. Con-
tact customer support.
SPFCOST(3)
An error occurred with comput-
ing the unicast path tree.
Run the LSDAllShow command. Contact
customer support.
MQ
QREAD (1)
A task was unable to receive a
message.
Run the command show
with the ID of the queue reported in the
error. Contact customer support.
QWRITE (1)
A task was not able to post a
message on a queue.
See “MQ-QWRITE Error” found later in
this chapter for more information.
SYS
NOMEM (1)
The system’s memory is
exhausted.
Reboot the switch. Contact customer
support.
SYSCALL (2)
A system call into VxWorks
failed.
Reboot the switch. Contact customer
support.
TIMERS
ENQFAIL (1)
An error occurred while setting a
timer.
Reboot the switch. Run the commands
actTimersShow
and timerShow
MSG (3)
The timer task received an
unknown message.
Contact customer support.
0 +
"
*
"
)