Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 65)

support.dell.com PowerVault 51F Commands 4-3
Community 4: public (ro)
No trap recipient configured yet
Community 5: common (ro)
No trap recipient configured yet
Community 6: FibreChannel (ro)
No trap recipient configured yet
sw5:admin>
Table 4-2 describes the fields for the agtcfgDefault command.
Table 4-2. agtcfgDefault Command Field Descriptions
Field Description
sysDescr The system description (in MIB-II definition). The default
value is set as Fibre Channel Switch.
sysLocation The location of the system (switch) (in MIB-II). The default
value is set as End User Premise.
sysContact The contact information for this system (switch). The default
value is set as Field Support.
swEventTrapLevel The event trap level in conjunction with an event's severity
level. When an event occurs and if its severity level is at or
below the set value, the SNMP trap, swEventTrap, is sent
to configured trap recipients. By default, this value is set at
0, implying that no swEventTrap is sent.
Other possible values are:
0 = None
1 = Critical
2 = Error
3 = Warning
4 = Informational
5 = Debug
See “errShow” found later in this chapter for related
information.
authTraps authenticationFailure (the authentication trap) is transmitted
to the configured trap recipient in the event the agent
received a protocol message that is not properly
authenticated.
In the context of SNMPv1 and SNMPv2c, this means that a
request that contains a community string is not known to
the agent. The default value for this parameter is 0
(disabled).