Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 84)

4-22 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
After each prompt, the current value is shown inside brackets; the user may enter one
of the following commands:
•
keeps the current value
•
An IP address in conventional dot (.) notation
•
The word none
•
cancels any changes
•
accepts any changes but skips remaining input
A final prompt asks whether to set IP addresses to the new values. Typing y installs
the new values; typing n delays the changes until the next switch reboot. If the Ether-
net IP address being used to Telnet to the switch is changed and the user types y ,
then the Telnet session is closed.
ipAddrShow
The ipAddrShow command displays the switch’s IP addresses. The fields are
described in Table 4-11.
login
The login command allows a user to login to the switch with a different user name
and password, without first logging out. If the user is connected via a Telnet or login
session, then the session is left open unlike using the logout command.
This command is typically used to gain access to commands that are not allowed at
the current user level.
logout
The logout command allows a user to logout from a Telnet, login or serial port ses-
sion. Telnet and login connections are closed, the serial port returns to the
login:
prompt.
The commands exit and quit are accepted as synonyms for logout, as is
typed at the beginning of a line.
nsAllShow
The nsAllShow command displays the (24-bit Fibre Channel) port IDs of all devices in
all switches in the fabric. The nsAllShow command optionally takes an integer
parameter, the value of the FC-PH type. The possible values for FC4Type are:
•
5 - FC-IP
•
8 - SCSI-FCP
For example, nsAllShow 8 shows all SCSI-FCP nodes. If the parameter is not pro-
vided, then all Nx_Ports are displayed.