Dell PowerVault 51F (8P Fibre Channel Switch) - Manual (Page 64)

4-2 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
agtcfgDefault
This agtcfgDefault command allows admin to reset the configuration of the Simple
Network Management Protocol (SNMP) agent to factory defaults, as shown in the fol-
lowing example:
switch:admin> agtcfgDefault
Committing configuration...done.
agent configuration reset to factory default
sw5:admin> agtcfgShow
Current SNMP Agent Configuration
Customizable MIB-II system variables:
sysDescr = Fibre Channel Switch.
sysLocation = End User Premise
sysContact = Field Support.
swEventTrapLevel = 0
authTraps = 0 (OFF)
SNMPv1 community and trap recipient configuration:
Community 1: Secret C0de (rw)
No trap recipient configured yet
Community 2: OrigEquipMfr (rw)
No trap recipient configured yet
Community 3: private (rw)
No trap recipient configured yet
h Move one space left
l Move one space right
R Replace text
x Delete one character
u Undo last change
Enter command mode
or
Back up
Erase all current text and begin again
Table 4-1. Command Line Editing Commands (continued)
Command Description