Removing the microprocessor, Removing the – Dell XPS/Dimension XPS User Manual
Page 109

Removing and Installing Parts
109
Removing the Microprocessor
NOTE: It is recommended that only a technically knowledgeable person perform this procedure.
CAUTION: The processor can get very hot during normal operation. Ensure that
the processor has had sufficient time to cool before you touch it.
1
Follow the instructions in "Before You Begin" on page 80.
2
Open the computer cover (see page 82).
3
Remove the microprocessor airflow shroud (see page 105).
4
Remove the microprocessor heat sink:
a
Remove the retention module clip by pressing in on the tab and lifting the
retention module clip up.
b
Pull the release lever out until the heat sink is released.
c
Lift the heat sink away from the microprocessor.
NOTICE: Lay the heat sink down with the thermal grease facing upward.
NOTICE: If you are installing a microprocessor upgrade kit from Dell, discard the original heat
sink. If you are
not installing a microprocessor upgrade kit from Dell, reuse the original heat
sink when you install your new microprocessor.
5
Pull the release lever straight up until the microprocessor is released.
heat sink
microprocessor socket
release tab
retention
module clip
retention
module
G0550bk1.book Page 109 Thursday, July 10, 2003 1:55 PM