Microprocessor, Installing the microprocessor – Dell XPS/Dimension XPS User Manual
Page 107

Removing and Installing Parts
107
Microprocessor
CAUTION: Before you perform this procedure, follow the safety instructions on
Installing the Microprocessor
NOTE: It is recommended that only a technically knowledgeable person perform this procedure.
CAUTION: The processor can get very hot during normal operation. Ensure that
the processor has had sufficient time to cool before you touch it.
1
Follow the instructions in "Before You Begin" on page 80.
2
Open the computer cover (see page 82).
3
Remove the microprocessor airflow shroud (see page 105).
If you are replacing a microprocessor, follow steps 4, 5, and 6 in "Removing the
NOTICE: You must position the microprocessor correctly in the socket to avoid permanent
damage to the microprocessor and the computer.
4
If the release lever is not extended to the release position, move it to that position.
5
Align pin-1 (the imprinted corner) of the microprocessor and pin-1 of the socket.
NOTICE: Microprocessor pins are delicate. To avoid damage, ensure that the microprocessor
aligns properly with the socket, and do not use excessive force when you install the processor.
6
Carefully set the microprocessor in the socket and press it down lightly to seat it.
7
Rotate the release lever back toward the system board until it snaps into place,
securing the microprocessor.
G0550bk1.book Page 107 Thursday, July 10, 2003 1:55 PM