Dell XPS/Dimension XPS - Manual (Page 102)

102 Removing and Installing Parts
www
.dell.com | support.dell.com
6 If you are installing a new floppy drive rather than replacing a drive, remove the front-
panel inserts.
From inside the drive bay, gently press on each side of the insert until it pops out.
7 Check all cable connections, and fold cables out of the way to provide airflow for the
fan and cooling vents.
8 Close the computer cover (see page 117).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
9 Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any
software required for drive operation.
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 13.
Removing a CD/DVD Drive
1 Follow the instructions in "Before You Begin" on page 80.
2 Open the computer cover (see page 82).
3 Disconnect the power and CD/DVD drive cables from the back of the drive.
G0550bk1.book Page 102 Thursday, July 10, 2003 1:55 PM