Dell XPS/Dimension XPS - Manual (Page 108)

108 Removing and Installing Parts
www
.dell.com | support.dell.com
8 Install the heat sink:
a Insert the notched end of the heat sink onto the end of the retention base that is
opposite the hinge.
b Lower the heat sink until it fits securely in the base.
c When the heat sink is secured, pivot the rentention module clip back until the tab
snaps into place to secure the heat sink.
9 If you installed a microprocessor replacement kit from Dell, return the original heat
sink assembly and microprocessor to Dell in the same package in which your
replacement kit was sent.
10 Replace the airflow shroud (see page 106).
11 Close the computer cover (see page 117).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
12 Connect your computer and devices to electrical outlets, and turn them on.
pin-1 corners of microprocessor
and socket aligned
microprocessor
microprocessor
socket
socket lever
G0550bk1.book Page 108 Thursday, July 10, 2003 1:55 PM