Dell DX6000G User Manual
Page 138
138
Installing System Components
• SAS backplane power cable connector
• System board power cable connectors
11 Replace the expansion-card risers. See "Removing the Front Bezel" on
12 Install all expansion cards. See "Installing an Expansion Card" on page 89.
13 Reinstall the integrated storage controller card. See "Installing the
Integrated Storage Controller Card" on page 93.
After connecting the SAS cables to the controller, make sure to place the
cables under the guide on the end of riser 1.
14 If applicable, reconnect the RAID battery cable to the PERC controller card.
15 If applicable, reinstall the iDRAC6 Enterprise card. See "Installing an
iDRAC6 Enterprise Card" on page 102.
16 If applicable, reinstall the iDRAC6 Express card. See "Installing an
iDRAC6 Express Card" on page 100.
17 Replace the system board shroud. See "Installing the System Board
18 Close the system. See "Closing the System" on page 81.
19 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
20 If applicable, replace the front bezel. See "Installing the Front Bezel" on
book.book Page 138 Wednesday, December 22, 2010 2:13 PM