Dell DX6000G - Manual (Page 125)

Installing System Components 125
Figure 3-23. Replacing the System Battery
4 Locate the battery socket. See "Jumpers and Connectors" on page 163.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 To remove the battery, support the battery connector by firmly holding the
positive side of the connector.
6 Press the battery toward the negative side of the connector and lift it up
out of the securing tab at the negative side of the connector.
7 To install the battery, support the battery connector by pressing down
firmly on the positive side of the connector.
8 Hold the battery with the "+" facing the plastic connector on the system
board and slide it under the securing tabs.
9 Press the battery straight down into the connector until it snaps into place.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
2
3
1
book.book Page 125 Wednesday, December 22, 2010 2:13 PM