Dell DX6000G - Manual (Page 102)

102 Installing System Components
3 Pull back slightly on the retention standoff tab at the front edge
of the card and gently lift the card off the retention standoff. See
Figure 3-20.
4 As the holder releases from the standoff, the connector under the card
disengages from the system board connector.
5 Angle the card so that the notch on the card slips through the clip on the
system board.
6 Close the system. See "Closing the System" on page 81.
7 Reconnect the system and peripherals to their power sources, and turn
them on.
Integrated Dell Remote Access Controller 6
(iDRAC6) Enterprise Card (Optional)
Installing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 80.
3 Remove the system board shroud. See "Removing the System Board
Shroud" on page 98.
4 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel.
5 Angle the card so that the RJ-45 connector fits through the back-panel
opening. See Figure 3-14.
book.book Page 102 Wednesday, December 22, 2010 2:13 PM