Dell PowerEdge R810 - Manual (Page 66)

66 Using the System Setup Program and UEFI Boot Manager
Integrated Devices Screen
Hard-Disk Drive
Sequence Determines the order in which the BIOS attempts to
boot from hard drives in the system during system
startup.
USB Flash Drive
Emulation Type Determines the emulation type for a USB flash drive. If
Boot Mode is set to UEFI, this field is disabled.
Boot Sequence Retry
(Disabled default) If this field is enabled and the system has failed to boot,
the system reattempts to boot after 30 seconds.
Option Description
Integrated SAS Controller
(Enabled default) Enables or disables the integrated SAS controller.
User Accessible USB Ports
(All Ports On default) Enables or disables the user accessible USB ports.
Options are All Ports On, Only Back Ports On, and All
Ports Off.
Internal USB Port
(On default) Enables or disables the internal USB port.
Internal SD Card Port
(On default) Enables or disables the internal SD card port.
Redundancy
(Disabled default) Enables or disables the mirror mode.
Embedded NIC1 and
NIC2
(Enabled default) Enables or disables the operating system interface of the
embedded NICs. The NICs can also be accessed through
the system's management controller.
Embedded Gb NIC x
(Enabled default)
Enables or disables the integrated NIC. Options are
Enabled and Enabled with PXE. PXE support allows the
system to boot from the network.
MAC Address Displays the MAC address for the integrated 10/100/1000
NIC.
Capability Detected
(Disabled default) Displays the NIC features of the LOM NIC hardware key.
NOTE: Some LOM features may require the installation of
an additional driver.
Option Description
book.book Page 66 Thursday, February 18, 2010 2:06 PM