Sata settings screen, Boot settings screen – Dell PowerEdge R810 User Manual
Page 65

Using the System Setup Program and UEFI Boot Manager
65
SATA Settings Screen
Boot Settings Screen
C1E
(Enabled default)
When set to Enabled, the processor(s) can switch to a
minimum performance state when idle.
C States
(Disabled default)
When set to Enabled, the processor can operate in all
available power states.
Processor X Family-
Model-Stepping
Displays the family and model number of each processor.
A submenu displays the core speed, the amount of cache
memory, and the number of cores of the processor(s).
Option
Description
Embedded SATA
(Off default)
ATA Mode enables the integrated SATA controller. Off
disables the controller.
Port A
(Off default)
Auto enables BIOS support for the device attached to
SATA port A. Off disables BIOS support for the device.
Option
Description
Boot Mode
(BIOS default)
CAUTION:
Switching the boot mode could prevent
the system from booting if the operating system was
not installed in the same boot mode.
If the system operating system supports Unified
Extensible Firmware Interface, you can set this option to
UEFI. Setting this field to BIOS allows compatibility
with non-UEFI operating systems.
NOTE:
Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
Boot Sequence
If Boot Mode is set to BIOS, this field tells the system
where the operating system files needed for startup are
located. If Boot Mode is set to UEFI, you can access the
UEFI boot manager utility by rebooting the system and
pressing
Option
Description
book.book Page 65 Thursday, February 18, 2010 2:06 PM