Dell PowerEdge R810 - Manual (Page 57)

About Your System 57
Warning Messages
A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
Write fault
Write fault on
selected drive
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard-
drive subsystem. Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected. See
"Troubleshooting a USB
Device" on page 162,
"Troubleshooting an Internal
USB Key" on page 171, and
"Troubleshooting a Hard
Drive" on page 174.
Warning: QPI
links operating
in Slow Speed
Mode.
The processor has bent pins.
The processor is not properly
seated on the processor
socket. Reseat the processors. See
"Removing a Processor" on
page 134 and "Installing a
Processor" on page 138.
If the problem persists, see
"Getting Help" on page 195. Warning: QPI link
between
Port and
Y1> failed.
Warning: QPI link
between
Port and
Y1> degraded to
half-width.
NOTE: For the full name of an abbreviation or acronym used in this table, see the
Glossary on the Dell Support website at support.dell.com/manuals.
Message Causes Corrective Actions
book.book Page 57 Thursday, February 18, 2010 2:06 PM