Dell PowerEdge R810 - Manual (Page 29)

About Your System 29
E1624 Lost power
supply
redundancy.
Check PSU
cables.
The power supply subsystem
is no longer redundant. If
the remaining power supply
fails, the system will shut
down. See "Troubleshooting
Power Supplies" on
page 167.
E1626 Power Supply
Mismatch.
PSU1 = ### W,
PSU2 = ### W.
The power supplies in the
system are not of the same
wattage. Ensure that power
supplies with matching
wattage are installed. See
the Technical
Specifications outlined in
your system’s Getting
Started Guide.
E1629 Power
required >
PSU wattage.
Check PSU and
config.
The system configuration
requires more power than
the power supplies can
provide, even with
throttling. Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
E1631 System power
draw exceeded
threshold.
Contact
support.
The processors and memory
throttling is not sufficient to
keep system power
consumption below the
maximum safe level with
current power supply
configuration. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 195.
E1632 PowerSafe
event.
Contact
support.
The processors and memory
have been throttled to keep
system power consumption
below the maximum safe
level with current power
supply configuration. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 195.
Code Text Causes Corrective Actions
book.book Page 29 Thursday, February 18, 2010 2:06 PM